Having an issue that all 3 codes are coming up on the monitor when you start the machine, but its not low on either fluid. All sensors are plugged in and some are even new. I plugged into the computer and cant find anything about the level sensors anywhere to see what they are reading. Is there a ground somewhere that these 3 sensors use maybe
post a serial prefix and ill see if i can attach the schematic for you
Kkt01036 That would help alot, thanks!
check messages. I sent your machine schematic and also air conditioning schematics for that serial in case you ever need them later
im assuming your 3 codes for low fluid you are referring to coolant hydro and engine. 235 will be the ground wire on all three of the level switches and they could share the same grounding point. when you plugged in were there any actual specific codes or events active?
No, no codes no active events and no logged events either.. I've got other machines that dont even have a coolant level sensor and the warning doesnt show up on the laptop top, not sure if its suppose to... Also where is ground 235 located? Im bad at reading the schematics