Heavy Equipment Forums Heavy Equipment Community

2007 bobcat s300 hydraulics and not functioning

Tim Waldner ยท 2024-07-14 16:58

Good afternoon everyone did anyone have an issue on a 2007 bobcat s300 the hydraulics aren't functioning i cant move it not even drive with it when i start it and press the green button to activate the hydraulics and disengage the parking brake just the seat bar and the green activate button comes on. The lift and tilt and the traction light doesn't come on when i start the machine there on for a couple seconds than they go off dose anyone know what to do or what to check thanks

Replies6
  1. #1Cliffy2024-07-14 19:48

    First you have to determine if the problem is electrical or mechanical. Can you hear belt squeaks when increasing revs from cold? Does the engine load up when you press travel levers?

  2. #2ozarkag2024-07-14 20:35

    Any active codes? Press and hold the light button. Will only display active codes so start and try to unlock first

  3. #3Tim Waldner2024-07-15 08:55

    its an electrical issue the belt squeaks when you start it up you can also see the belt when you look in the engine compartment over where the battery is at its nice and tight i can get my hand in there to check the tension

  4. #4Tim Waldner2024-07-15 08:58

    i cant actually check the codes my hour meter is shot it doesn't display anything but we had the board where the bics is in in a different skid loader and worked like a dream

  5. #5Tim Waldner2024-07-15 09:10

    keep in mind my skid loader dosent have the foot controls its got the selectable joystick control

  6. #6ozarkag2024-07-16 19:59

    Gonna have to have codes. Might need to have bobcat plug in, but might be cheaper to fix that dash. . ..