Heavy Equipment Forums Heavy Equipment Community

2017 SkyTrak 10054 telehandler – frame tilt issue rear tilt cylinder not moving?

sepulchral ยท 2025-06-29 23:20

What would cause the rear tilt cylinder to stop responding? Seems like it is locked or something. When i frame tilt, only the front wheels angle...

Replies6
  1. #1MarshallPowerGen2025-06-30 00:03

    All the time, or only with the boom up or out?

  2. #2sepulchral2025-06-30 00:14

    all the time F4 fuse (10A) keeps blowing also, but have no clue what it is.

  3. #3griffin&sonsLV2025-06-30 22:32

    Raise the boom up past 40 degrees and see if the sway comes back if you do, could be bad relay for the RAS

  4. #4tractormech2025-06-30 22:35

    Does the rear cylinder have several solenoids on it? If so, mark the wires , unplug all of them and see if it quits blowing fuses. Plug them back in one by one and see If it blows the fuse. unplug the proximity switch/ switches too and see if it quits blowing. If it does start checking wiring. I think it will be one of the solenoids. Good luck.

  5. #5sepulchral2025-06-30 23:17

    ended up being a short at the boom angle sensor/switch. disconnected the sensor and fuse didnt pop

  6. #6tractormech2025-07-01 21:34

    So it was the proximity switch. Glad you got it figured out.