P385B-3851 I cannot for the life of me figure out how to get this thing back to normal. It won’t go in high idle. One of our techs regen the machine and now these codes won’t go away. Attached are pictures of the codes
Follow this procedure out and see where it takes you.
Awesome I’ll give it a shot tomorrow. Thank you!
Probably needs a def manifold/sensor. Pull the cover off over the fuel tank and def tank. With key off unplug the 4 pin connector to the def manifold. On machine side, check ground and can wires. Can wires should be 60 ohms. With connector unplugged, turn key on and check power. Should be close to battery voltage. Also check voltage on can wires. Voltage reading on each can wire be around 2.3 volts to 2.8 volts. Should add up to 5 volts. If all that looks good then slap a new manifold in it. Codes should become logged but might take a few mins of run time. Or just hook up ET and reset the operator inducement. I've found is easier and cheaper to just replace the whole manifold assembly that replace just the sensor. It was like $100 more for an assembly than just a sensor.
Dang, even a paver is sucking the pig ****?
Im not sure what he did to fix it but im pretty sure one of our techs did what you described and i havent heard anything else on it
That is a def inducement code. You can't clear it.....has to have cat et