333D pulling to right when moving forward . No codes
First thing I would try is a Hydrostatic calibration. Do you know how to access the "SERVICE MENU"?
Sorry do not know how to access menu
Please post the entire machine serial number. Before we jump to calibration, is this machine an "EH" machine or mechanical levers?
EH joy sticks
Try a calibration first. Check your messages.
Printed procedure and will try when machine comes back in this week Thanks and will advise results
Ran procedure today and appears problem solved when machine shut down today. Will recheck again after holiday break thanks for your help hope l can get some help on my other posting about hyd oil overheating when using high flow
1200 RPM 84 deg with plug in fan solenoid Fan 1173 RPM 1200 RPM 84 deg with plug out of fan solenoid Fan 1418 RPM 1750 RPM 86 deg with plug out of fan solenoid Fan 2048 RPM
Are these your fan speeds? Is the engine set to full throttle? The oil needs to be 110*F (43*C) for an accurate reading. Re-run the fan speeds with the oil at or above 110*F (engine speed at full throttle).
Full throttle @111 deg 2505 RPM with fan solenoid unplugged
Spec is 2350-2600 rpm, so your reading looks good. The fan is turning counterclockwise when viewing from the rear, correct? If only the oil is getting to an overheat condition (setting codes and tripping alarms), then I suspect either the cooling fins on the cooler are not clean enough, foam seals around the cooling package are missing, issue with the attachment, or the system relief or the high flow relief setting is too low.
Yes , fan is turning counterclockwise when looking from behind machine Checking again for missing foam seals , checking attachment , not sure about relief or high flow settings