Any ideas on how to reset this?
Hi Cue. What is the serial number of the machine? I have manuals regarding the machine, But I need to know what PIN model the machine is. Can share them with you.
Extraction form the manual: 1. Make sure that there is enough room above the bin to be able to lift it fully. Look for any hazards like power lines or overhead obstructions. 2. Make sure there is no one directly behind the truck as the bin may hit them as it is lifted. If possible, cordon off this area to make sure no one enters it while you are calibrating the sensor. 3. Make sure that the bin is empty to prevent tipping a load/water/heavy objects in an undesirable place. 4. Start the engine. 5. Go to Menu> Machine Config> Bin. 6. Ensure that the bin is completely on the chassis. 7. Select "Zero Position" and then press and hold the middle SDC button to accept the bin zero calibration. 8. Once the value has been accepted, raise the bin fully. The bin will go all the way to the mechanical end stops when the Bin Calibration menu is selected. 9. Scroll to "Fully Lifted" and then press and hold the middle SDC button to accept the bin fully lifted calibration.