Heavy Equipment Forums Heavy Equipment Community

Bobcat 331 table gets stuck in one spot.

Jd plbg ยท 2015-01-03 02:53

I was hoping you all could help. I have a bobcat 331 that gets stuck at the same spot when rotating the cab. At roughly 20 degrees it will stop and I will rotate it back the other direction for a full 360 degrees and it will stop in the same spot. Any ideas on where I should begin? Thank you

Replies4
  1. #1Mobiltech2015-01-03 10:26

    Sounds like there's something stuck in one of the teeth on the ring gear.

  2. #2melli2015-01-04 16:08

    Any chance the turntable lock is partially engaged?

  3. #3Mobiltech2015-01-05 11:09

    That is quite possible.

  4. #4WhyWhyZed2015-01-05 12:33

    we had a similar size Bobcat where the slewing lock pin would catch - I can't remember if something was just unthreading.