Have a 2017 Case 2050M dozer. Dealer tech came out and said it had a bad def quality sensor. Replaced the DEF sensor/sender but Im stilling getting a few fault codes yet. #19225 engine can c bus off error and #3436 engine scr inducement not available. Any thoughts? Will I need to have the tech come back and do a reset or something? Thanks!
I know this is old check the CANBUS connector next to the ECU it's the yellow connector to left this is on a 1150m 2019 if it is not connected all the way it will throw that code. I found that out trying to disconnect it the yellow clip broke while I was checking for an issue. This will also cause an Inducement because it's not reading any of the engine sensors.