Hi to all, Have aquired a Case 580k with lots of loose wires. Although it seems to basically function OK can only start it by jumping the starter solenoid to battery. So a wiring diagram would be a great help to start tidying up what hopefully will be a good work horse. Regards JD
Remember please that this is a Wheel Loader section. Be sure to post a thread about a Case 580K in the "tractor/loader/backhoe" section, im sure they would be glad to help you out then =D
I don't have a wiring diagram for your backhoe. But if you take the cover off on the floor panel in front of the seat, you will be able to see the top of the transaxle. There are two detent swiches with screws on them. the one at the rear is your safety neutral switch. Check for power there when your in start posistion. Your switch mite be defective. Try this.
Case wiring Thanks. Have sorted it. Was ignition problem. JD