I have a 259D Skidsteer and the engine stopped running while in use and Code 41-4 appears on the screen. I tried to find the problem and located the fuse p[anel behind the cab and a 20 Amp fuse was blown. I replaced it and it blew it to. Could there be a shorted wire or bad connection?
Two things, serial number for machine and fuse description or fuse number for the blown fuse. Shouldn’t be terribly difficult to run down the problem with that information and a wiring schematic.
41-4 is a problem with the 8v sensor power supply. Still needs a Serial Number to identify the test procedure though. As @ahart mentioned you will also need the electrical schematic to help you in tracing wiring.
Cat 259D SN:CA40250DKFTL16390. Fuse Box just nbhehind the cab with a blue fuse holder and fuse is 20Amp
Here's the troubleshooting for 41-4. If a complete electrical schematic would help you're welcome to one. Here's also something regarding fuses to help you identify exactly which function(s) the blown fuse is serving.
Thanks, i will have my guy look into this and see if he locate a short.
I take it you don't have an Operation & Maintenance Manual either.? That's where the article about the fuses came from. If you maintain the machine yourself it's a very good investment. One recommendation is not to skimp on changing the fully synthetic 85W/140 oil in the drive motors every 500 hours. New drive motors are now priced at over $8k each. Here's a brand new OEM manual on CD - 259D O&MM
To the OP. Check your messages, an electrical schematic is on the way.