Got 3 of these pretty much same issue im trying to get handled 2 are 924k’s the other is a 926m pretty much all will hold a little bit when running then as soon as engine is off there gone today i tried charging nitrogen cylinders per sis and verifying pressure was at 0 in et before charging and it made no difference they were sitting at ruffly 500psi and sis called for 800 for temp, im getting at a lose were to turn to with them
Just as a place to get started, you have done the manual adjustment procedure correct? If they are adjusted properly and there’s no pressure at the release line, it should hold assuming there isn’t an issue with the spring in the brake assembly.
Brake was adjusted, i looked up the caliper diagram since you said this did not now it had springs in it see most parts are unserviceable now and sold as a reman. Guess ill have to try that thanks
Just a update. Replaced caliper holds perfect now thanks
Hello, I'm looking for advice as our 2019 926M does not brake either. Where to start looking? 7000 hours on it
Screen shot’s of adjustment