9kk01025 My throttle has not been working for the most part. Cables seem loose so am trying to calibrate and adjust the cables. I have the document for calibrating and replacing but i cant seem to get it to work or don’t understand it. Basically from what i can understand i go into calibration mode and push buttons until i get the “ACP”. From what i understand this is to move the motor to position 10? If so mine is not moving and i get [-3] Then i adjust the Accelerator cable tight with the Pulley in full throttle and have a bit of slack on the other cable. When i try this the cable is too short as the cable is not in the correct position? Is there a test to see if the motor is working correctly?
Hello sir how you enter to the calibration mode. I try to follow from your image file but it work. I try to press and hold ACE switch then press and hold Washer switch many time but it's still not work.); it not showing the AC on the Monitor