I have a D5C LGP series III SN 6ZL00259 I am replacing the spider gears (universal joints) and the transmission seals and real drive seals. these are both of the seals on either end of the drive shaft (universal). I got the parts from the Cat dealer the transmission has 1 seal and the real drive side has 2 seals and 1 o-ring. does anyone have the procedure for replacing the u joints and seals? are there any special tools required? is it best to assemble the block and 2 universal joints and then install the assembly? I am concerned about getting the seals installed properly i appreciate any help/ experience/ advice I am concerned about getting the seals out and installed properly appreciate any help
No replies yet.