Have this machine under my troubleshooting care, a lot of hands have been in it before me and I am making some headway. Currently going to replace ignition coil due to no voltage. My question is do this machines have any known problems with harness or crank shaft sensors to prevent signal to coil pack? Thanks for any advise in advance,
Just so the information is here for someone else. On this machine there was (2) relays by the gas/lp switch, the one in the back with (black wire) I sent 12V to using a power-prob and it was released the relay to gain full function once more to allow engine to start. I did change both relays just because of age. But that fixed the issue, that relay controls signal to ecu and throttle mixer.