Got an issue here that has brought me to a dead end. Issue is as follows. Machine ran fine all day. Go to move next day and it will run but not move whatsoever. Only have 3 lights up on display. 4 shine when key is turned. All grounds are good confined. Traced the power wire all the way back to a box behind a cover on the left hand foot well. Wire goes into a 20 or so pin connection. I have 2 volts max on this wire at the back of machine where it connects to sensor. I also have 2 volts where it goes into multi pin assembly. Is 2 volts normal operating range or is that low. Any insight is appreciated thanks. Yes engine speed sensor is new.
is the speed sensor adjusted correctly?