To those of you that own and or operate a D6R What is the GPH, I'm guessing around 8 gals. Thanks, DP
9 1/2 to 10 hour day in tuff dozing better be looking for fuel. Rebuilt fuel pump this summer,it's a strong runner,but was before. It doesn't smoke overly much.Not as much as my older D6H:usa
Constructo, do you know the gallons per hour? Thanks
I would say somewhere around 8-11 gallons an hour depending on what you are doing. Like Constructo said when you hit 10 hours you better be looking for fuel.
I wasn't sure what the tank holds ,so got the operator manual out and it say 101 gallons,so 10 hours a tank,equal 10 gallon an hour. Usual that is if you hogging dirt like building pond with mud and heavy moist dirt. All the 3306 engine that i have had in D6C,D6D,D6H and my D6R run about the same,as far as hours worked to tank went 9 1/2 to 10hours (D and C had the fuel turned up).The D6C was like 72 gallon tank and the D6D was 78 gal ,i'm close ,but not exact. D6C and D6D had straight blades and are not as tall as the R and H dozers. The IG and XW D6R,H machine that has the 30" pads, they run a 11' 6".A lot of people don't realize that the D6R and D6H has blade cap of about 7.6 cubic yards compared to the D and C that are around 3.4. Don't have my book right here handle ,but i'm close. Hope that helps !:usa
I used a rented D6R last summer to R&R dirt 6ft. deep for a new apartment building. We were working 8-9hr days and used between 70 and 75 gal per day over a 1 week period. The ground was sandy loamy soil and was fairly easy to push - no ripping needed. Some of the time was used for track rolling for compaction. The D6R was a pretty low hour machine and in really good shape, especially for a rental. Hope this helps.
on a 6R series 1 35-40 ltr pr hour but on a new D6R series 3 over a period of 3600 hours i had an average of 23 ltr pr hour but i will agree that when hard pushing heavy dirt no more than 9.5 to 10 hours on a tank
Dpete, Here is a thread that I started awhile back on what I have done to cut the gph consumption on my 6R.
d6peg, Never thought about doing that with the dozer but it makes sense. One question did backing off on your rpms have any effect on your operating temps? During the summer here the R really likes to heat up especially when pushing brush. The series 3 has the hydraulic fan and seems to run alot cooler than the belt/fan combo. Also on our 2006 6R you would have to control the rpm's with the decellerator since throttle is controlled with a toggle switch.
JBL, Backing off the rpm's might have increased the water temp a little but very little. We had a 108 degree day in June this last year and I happened to be pushing brush for a new fence line and it got pretty warm but I never had to stop. You can set your rpms with the toggle switch, just set the rpm at what speed you want with the decel pedal and hold the toggle down for 5 sec., then release the toggle and the motor will not rev past the set rpm.
D6peg, thanks for heads up on setting the rpm with the toggle switch.