have a 580e backhoe

1. #1fixou8122015-10-04 10:47

   Are you a Robot Wanda?

2. #2lantraxco2015-10-04 15:36

   On the 580E, the four injector lines from the pump should connect to the top of the injectors. Hold the injectors tight with one wrench, loosen the tube nuts on top with a second wrench, about one full turn is usually good. Throttle about half, crank the engine over for a few seconds, when you see fuel pulsing from each joint stop and tighten all four lines. Try and start it, may stutter a bit and then take off.

3. #3Wanda2015-10-04 15:57

   Lol no sir

4. #4Wanda2015-10-04 16:03

   Thank you. We Will try it

5. #5Wanda2015-10-05 09:25

   Really, Really, and that is all you have? if I knew how to do it, you think I would be on here,,,