Good morning, I have been restoring a 1996 Genie Z45/22. It has a LGR423 Ford 4 Cylinder for a motor and I removed the LP portion of wiring. I have everything working now except the drive function is kicking my ASS!!!! I have checked voltage to the card on terminaals #1 and #2 which is above +12VDC and then I check Voltage at #2 to #3 and it also is steady around 6-7 Volts. When I check voltage on high side at terminal #10 which outputs to Joystick its all over the map...... Between 7.5 volts to 11.0 volts. I assumed my HP limiter card was bad so I replaced it and have the same problem........ Anybody have some advice? thanks, Jim
No replies yet.