Heavy Equipment Forums Heavy Equipment Community

JD 244j no information on monitor or turn signals

1957gman ยท 2021-12-01 09:30

Hi All. new here : I have a 2012 JD 244j that i purchased used last March. Today when I started up there was not infomation on the display monitor.Monitor lights up but no information on it.. Also no turn signal or emergency flashers. JD is a week out for service any had this problem? Thanks

Replies5
  1. #1mg23612021-12-01 11:57

    Welcome to HEF 1957gman ! Serial number?

  2. #21957gman2021-12-01 13:32

    thank you Serial #1LU244JXZB028767 UPDATE: display monitor started working but trurn and emergency flashers still not working..

  3. #3mg23612021-12-02 05:07

    Check your F07 10A fuse. Also check the K1 flasher relay (not the K01). The K1 is labeled in the fuse block. Just below the fuses are 4 relays. The K1 should be the first on the left. For the monitor make sure the connections to the back are secure. Also check the ground behind the fuse panel. It will be on the floor of the fuse panel compartment.

  4. #41957gman2021-12-02 07:48

    Mg2361. Thank you, monitor seems to be working. Tighten the ground just in case. Next question is the k1 and the k01 flasher interchangeable? Thinking about swapping them out to see if the flasher will work. Thanks again for the help.

  5. #51957gman2021-12-02 08:07

    Mg2361, Thanks again for your help. Tighten all for the ground points and everything is working. Have great Holidays