Forklift cranks, has fuel, but is not generating spark. I replaced the spark coil pack too but still no spark. Are there safety (engine) permissives/sensors that i need to look at? ANy help would be great
Did you know it didn’t run when you bought it?
No I did not
How about a picture of the engine, so we've got some kind of idea, I think linde uses their own software on the newer stuff, and you can't hook up with any kind of a "generic" scanner.
Ugh. There could be a number of things causing this. Is the engine gas or propane?
Something I came across just prowling on what others have asked and posted. "Ideally you need a laptop with pathfinder/truck doctor to see what fault codes are showing, without lap top try looking at the fuses under the display there should be a 1 amp fuse this protects the module and is has blown try another and a 15amp fuse that suppy12v to the module. Check the speed sensor on the fly wheel ths also communicates with the module. If you have another truck on site try the module on that truck to confirm it has not gone down."
Brake or seat switch?
Any progress when/if you checked these fuses? "without lap top try looking at the fuses under the display there should be a 1 amp fuse this protects the module and is has blown try another and a 15amp fuse that suppy12v to the module. Check the speed sensor on the fly wheel ths also communicates with the module."
no progress. will try again, thanks for the inputs