Hey all...thoughts on a Massey Ferguson 300 Dozer/Drott...1980 yr i think...Had a drive today..had to really stamp on steering pedals but didnt have at full throttle...Blade would lift machine off ground...but rippers wouldnt lift the back up ,even if just using them....Drive sprockets got about 1cm on end of tooth thickness...but the track pins are say 40mm across & sitting in the sprocket{say 50mm in the scollop) about 5mm gap either side of pin...Is the track pins worn or wrong size sprocket or is this normal?? Should the track pins be a snug fit in the sprocket? Grousers about 30mm left on them....Chains/track pins didnt look worn etc...Thanks for any advise
No replies yet.