Appreciate any feedback Everything seemed normal with the monitor after last shutdown. Then came Helene. Got back on the excavator the day after to start clearing a path out.The monitor wasn't displaying properly nor were some of the monitor buttons working. The monitor is only displaying the back up camera full screen with hours data showing at bottom center of screen. Typically the camera image is partial screen with the remaining screen showing engine data. In addition the hours are shown top right typically Vs bottom center. Some of the monitor buttons work - hours, lights, wipers... Other buttons do not work - menu, travel speed, cam view The excavator operates normally just have no complete monitor data and only slow travel speed. I have turned off main disconnect and let sit most of day hoping for a reset - didn't happen. Also the cab was completely dry and the machine received no obvious damage from Helene. (this post is an edited version of a previous. I didn't know how to edit the original that was done hastily)
You will need to find out if any fuses were loose or burnt. Need to find out if there is correct positive and negative feeding the display, that is where I would start. Could very well be if the machine was out in tempestuous storm, that some plug ins got wet and are a little corroded. Just thinking about simple stuff to check. Simon C
Hi there having same fault on my case 130d was wondering if you ever found out the fault thanks
Hello Plz have u found the solution for this issue
Plz have u found the solution
Turned out the brain had malfunctioned and kept blowing a certain fuse. Replaced brain and problem solved
Plz could u give ur WhatsApp number For me i checked the fuses an all powers for main controller They are oky Its still shows the backup camera Also before this issue i hve tried to disable the anti-theft system After that the display dont shows nothing