right side foot pedal keeps getting locked out need to know what solenoid controls it
Sounds like a linkage problem to me. Did you lift the cab and look at it?
yeah linkage is fine the pedal acts like its in lock out pedal wont move give it a couple of seconds and it starts working again
std foot control or acs? :drinkup
it has std foot controls pedals acts like you have not activated it on the control panel
spool lock solinoids are located near the front of the control valve, at the linkage end 1" hex, approx 1 1/2" long, 2 (black) wires they are "inline" with the middle spool. the tilt may be facing the center of the machine or may be facing straight up :drinkup
That was my thought. The valve may have a chipped or torn seal causing it to hang up a bit. With an internal leak you could not see it from the outside.
typically an intermittent locking/unlocking would not be a damaged valve. in a damaged valve the spool may be "stiff" or not move at all. if a seal was torn or worn you'll have an external leak :drinkup
i switched both soleniods and there was two coils switched them to see if it would change pedals and it hasnt happened since so im stumped unless it i was a dirty plug but i checked all plugs no green or broken wires that i could see