I’m getting error codes 130 SID 254 FMI 2 and 3. I had sent the TECU for reprogramming because the machine was only working in manual mode (no crawling in auto). After reinstalling the reprogrammed TECU, the machine ran fine for about two hours, then the same issue returned. Now it’s also showing a new code: 128 SID 70 FMI 5. Any help would be appreciated.
You need install PROSIS ( with all DTC ,schematic and other)
Hi, thanks for your reply. The machine is working in a remote area where no Volvo dealership or support is available. Will Jaltest work for me to diagnose and troubleshoot these fault codes and electrical issues? Please let me know if it’s a good alternative to PROSIS in my situation.
Check PM
the 128 sid 70 fmi 5 is inlet air heater FMI 5 ○ Error message ○ Buzzer caution ○ Pin B5 is disconnected. ○ Feed cable open circuit ○ Defective fuse ○ Defective air heater ○ poor connection. the 130 sid 254 fmi 2 / 3 is internal malfunction of the TECU safety relay function Controller is off, and safety relay safety controller is off FMI 2 ○ Error message ○ Buzzer alarm ○ Central warning light ○ Internal malfunction in the T-ECU. (Safety relay of the function controller is OFF.) FMI 3 ○ Error message ○ Buzzer alarm ○ Central warning light ○ Internal malfunction in the T-ECU. (Safety relay of the safety controller is OFF.)