Heavy Equipment Forums Heavy Equipment Community

2014 Case Sr 200

Kimbo ยท 2026-04-21 22:03

Hi.Long story.In Australia hard to get info even from case.I have a 2014 case sr200. 784 hours. Bought at 770hrs. Builder 440 hours, mainly forklift at yard, & site 2nd owner 330hours Hobby farm. I have had it 7 months 12 hours on it. When fluid reached glass level tube noticed fluid drop about 1litre in 10 minutes use. Cannot get info or diagram or part nos on 2 low pressure hoses going to housing fixed to engine on right rear of engine looking at it. Has been leaking someone previous has thought it was the hoses & double clipped, but looks like housing seal, I presume this case drain filter & pressurizing maybe done seal in drive motor & leaking into chain case. Next checking chain case bung. Learning every day previous novices maybe driving 2 speed under load. Just need info on diagram & part nos of this housing & filter. Thanks for reading my ramble. Kimbo. West Oz.

Replies3
  1. #1alrman2026-04-22 15:52

    Hey Kimbo, That is quite a ramble.... Typically, when you start a machine the hyd oil level will drop a little. If the hydraulic oil is disapearing over use & there is no oil to be seen in the belly of the machine (or on the ground) the drive motor shaft seals are to be checked. - there will be way too much oil in the chain case of a leaking motor. The housing (on the engine) that is leaking sounds like it is the adapter #6 that is connected to engine oil filter housing. This sends the engine oil to the remote engine oil filter #19 at the LHS rear of the machine. If there is an oil leak at the housing a seal (#8 large quadring) is leaking. However the design of the adapter doesn't allow you to tighten it properly & keep the fittings for the hoses in the correct location. What many people do is throw the adapter & hoses away & mount the engine oil filter back on the engine - where it belongs. If you could post pictures it would certainly help us to see what you are talking about...

  2. #2Kimbo2026-04-23 04:19

    Hi. Thanks for your help. I will remove the hoses & reposition filter, same as 430 series 3 with same motor. New engine oil looked like hydraulic oil threw me.Checked chain case plugs right level & clean. Where are the chain case drain filters.Never much mention on servicing them. Cheers.

  3. #3Kimbo2026-04-23 04:54

    Sorry ment 2speed drive motor drain filter. Have found them.