it was operating right tuesday and when we started it thursday it would start and the bucket would move regular but the machine its self will not move. the parking brake light doesnt go off when u push it but it makes a sound like its trying to engage. then the stop engine light comes on and it starts beeping. it keeps saying engage hydraulics. im not sure if i accidently pushed something and caused it to dis engage the hydraulics. please help
Welcome to HEF 114484 ! Please post the machine serial number. Are the hydraulics enabled?
1TO331GMPHF315325 the light is not lit up. when running the only light on on the right side is the left green light
Light #3 should be lit. Press the button so the light lights up.
it wont light up it just starts beeping and flashing stop. it says engage hydraulics
If you scroll through the monitor, are there active and or stored codes? List any found.
what would cause it to work and move about 50 ft and stop then do the same thing again about a hour later. would a computer do that?
no codes
Let's start from the beginning. We need to confirm some things in a logical order. Did you wash the machine at all? When you sit in the seat, close the cab door, ignition on, start the engine, lower the seat bar, release the park brake, are any of the lights below still on?
I am having an issue similar to this as well. Light number 17 will not go off. The left lever will attempt to move the tracks, but bogs down because the bucket is lowered then sets the parking brake until I cycle ignition. The right controller will not attempt to move anything except when I push the round buttons it sounds like it try's to work something under the skid steer. If i toggle the ISO button, the right controller will try to work the tracks, but same thing bogs down and sets parking brake.
Welcome to HEF Shane ! Let's start with the machine's serial number. That's very important. Then key on, press and hold the menu button until "SERVICE MENU" is displayed. Then scroll to codes and press select. Record and then post any codes, active and stored that you find in there. Then while in diagnostic mode, and if there are codes, clear them. Then cycle the ignition, start the unit, try to run it, and let's see what codes come back. Post them also.