i have a "no can" on the digital display. Any idea on what the problem can be?
Could be multiple issues. Check the following: 1. Check all fuses. If you have fuses under the left side door, remove and check them all, as they get corroded. If they are corroded, just replace them all, and clean the connectors. Check all the relays as well, and clean any corrosion. 2. With the key off, check the 9pin deutsch EST diagnostic connector, pin C and pin D should have 120 ohms + or - 10 ohms. If the reading is not correct, please advise. Probably a bad resistor. Resistor is inline in harness under the dash. (this is the connector that Case will plug into with their laptop. It should be under the left door, or in the cab.) 3. Check the wiring harness under the dash, it rubs through, and causes issues. Does this unit have a cab, or just a ROPS? Does the machine still move?
Sorry for late reply. We have been harvesting corn. The machine doe have a cab. I replaced the resistor because the wire was a little iffy. The machine would move but only a little at a time. Tore into the fnr lever and found a bad connection. Fixed the wire put everything back. Machine runs fine so far but when I turn ac on the blower doesn't work and the radio turns off. It's got me puzzled. Is this thing possessed? Any more answers will be a great help.
Does the blower work when the ac is off? Do any of the blower speeds work? Is it blowing the ac fuses when you turn on the ac? Does your machine have the fuse box with mini fuses or regular atc fuses?