I was wondering if anyone had experience changing starter on this machine. Was trying to find info online but found none. Thanks
Welcome to the Forums Pdfd1830!:drinkup What would you like to know? You've came to the right place for the answers. Before Nige gets here to ask, what's the serial number? There are different versions of the C model.
The serial number is: 8Cf00339 I am not sure of year of machine either
Is that the serial number of the engine? The serial number of the machine will start with 2ZN, BBX or LBP. 2ZN and BBX are the most common. My 953 is a BBX which is the later version. The machine serial number will give you the year model as well. Also moved this thread to the Track loader section.
Ok. I saw a cat plate on one side of the machine. Said model number 935C Product Identifacation number was 8CF00339 Where is the best place to look for serial number
Serial number I found another tag. Its bleached real bad from the sun
Serial number LBA08958 I think is the serial number
According to SIS the 8Cf00339 is the machine S/N for a 935C Track Loader with a build date of December 21, 1988. Not sure what you need to know about removing the starter, should be somewhat straight forward job. Disconnect negative wire at battery to kill all power to machine. This step is not listed in the Cat manual but I feel it is very important! Then per Cat service manual on SIS: 1. Remove the engine side panel, on the left side of the machine. 2. Put identification on the wires that are connected to the starting motor. Disconnect the wires from the starting motor. 3. Remove the three bolts that hold the starter to the flywheel housing. Remove starting motor (1). The weight is 27 kg (60 lb.). To reinstall: The following steps are for installing the starting motor. 4. Inspect the gasket for the starting motor. Install a new one if needed. 5. Put the starting motor in position and install the bolts that hold it in place. 6. Connect all wires to the starting motor. 7. Install the engine side panel on the left side of the machine. Then hook the battery back up and it should be good to go.