I need some feedback from anyone running a D6K2. The one I run has 300 hours and there seems to be excessive blade movement (slop). If I put the blade down on a hard level surface and then move the tilt control (kinda of fast) the C-frame moves (wobbles) a bunch. It doesn't look right to me, and the tilt cylinder will move about a half inch in and out before any blade movement. At times when pushing I can see the blade tilt slightly on its own depending on the hardness of the ground or the load on the blade. Cat is working on it now, but I was curious if anyone else has noticed this on a D6K2.
No replies yet.