Has any one ever tried a ball joint press to remove an install bushings in there bob tach? Just looking for a easy way. Need to tilt cylinders
shouldnt be a problem putting them in. getting the old ones out with a BJP may be difficult. i use the torch and hammer method myself..... :drinkup
i have an old tilt pin out of something bigger machined down to fit a new bush on it as an installer and when used with a FBH works as a good remover as well bush fits on the end and then there is a step out to a dia just less than the bore for about 4 inches then out to full size of old pin
sound like a great tool, I was thinking on making something like that myself. Do you use the same tool on the tilt cylinder bushings?