Hi guys, My bobcat e35 excavator shows C6021 on the display. Found in the manual : offset control out of range high but nothing more Anybody knows what cause the error and how to repair it ? It's a 2013 machine with only 1200 hours on it. Also the red general warning light is on on the display. Anybody that can help me ? Thanks in advance
Good day Kamei To have an error code there has to an electrical connection the term "Offset control" often used for the boom swing. This suggests that there may be a switch or proximity switch sensing the position of the offset. I suggest take a close look for this may need to be adjusted. If you have a wiring schematic to post may be able to help some more. Kind regards Uffex
What your serial and email ?
Sent it to you trough conversations as i can't sent you a PM
What was that serial number again ?
As i have figured out the fault comes always on after i got out of the machine. The offset boom works always when i start the machine but as soon as i got out once of the machine or pull up the left joystick i get always a the general warning picto will come on and a 3 beep signal (general waring in manual) and when i put the left joystick again down the warning don't get away and the offset boom can't be used until i start the machine again. Somebody have had a similar problem. Also what hydraulic oil needs in the machine 32 or 46 ? For using in Europe
Nobody have any clue about this problem or how to figure out the problem ?
Code C6021 Offset controller out of range high. Let's see what we can find .
Did you find anything where i can look to ?