hi guys ! Hoping somebody can let me know how to adjust linkage on this machine. Starts up and immediately wants to start moving to the right and another control issues which may be related is the left bucket control used to raise the bucket .. now it curls the bucket and raises simotaniously ... no independent operation. Not sure where to start ? Thank you !
I believe control rod adjustment is under floor board, there's one for right side and left. Undo lock nut on control rod. Adjust clevis until machine is in Neutral upon start up. It might take a few try's to get it right. Well your in there, check all linkage for worn holes and slop. Otherwise it may be very difficult to get it perfect. Above all else, work safe. Do adjustments, engine off, then test, when seated in cab, or block machine off the ground, you don't want to run yourself over. Not sure how much linkage involved in bucket controls, but its a good place to start.
Is this a newly purchased machine, or did this suddenly start?