About to remove and replace the engine in my 580C. It has the shuttle. Is there and easy way to deal with the torque converter as far as install. Ive never messed with one of these. THANKS!!!
Send Tinkerer a pm with your email, and I think he'll send you a digital manual.
There isn't much in the service manual about your question Martin. But this has been thoroughly discussed before on HEF. Here ---> HeavyEquipmentForums
I will add that if you leave the torque convertor in the shuttle when the motor is removed there is very little to no chance of damaging the oil seal that the convertor shaft slides into.