Iv changed controller computer tandem pump and both drive motors still won't track straight
What was the reasoning for changing all these parts? New parts or did you have the pumps and motors rebuilt? Also, is this a series 1, 2. or 3. What type of miss tracking. Is one side slower in forward and reverse? Is one side slower in just one direction? Does it miss track at all speeds? The computer will only compensate so much for miss tracking. Over about %15 difference the computer gives up and lets it miss track. Need more information before I can help.
i have the same problem with 650k series 1. forward and reverse the left track wont keep up no matter what speed its in. it does kick in and out sometimes. but if i move the joystick to the far right it will run normal speed with no glitching...no fault codes
What's the serial number
CAL 002075
Need more info. With machine off the ground in neutral does one track move? When you start moving off ground does one track move first? Has a link been removed from only one track? Did a dealer puts these parts in or did you do the work?
Not sure on this model but I believe you can zero the EDC’s with a pressure gauge and make travel adjustments there to some degree.
Misaligned servo Relief bypassing Loose solenoid positioning bolts Everything points to drive pumps for mistracking and no codes
i had it off the ground today and both tracks seem to start at the same time in both directions. i didnt change any parts on my machine
i replaced both speed sensors and problem solved