I have a CAT 299D2 XHP S/N DX200200. It has a work tool position sensor on the quick attach frame. I have attached a drawing and BOM. My question is the drawing looks to show a plug that I have circled with a question mark, I know for a fact that there is a plug at the sensor (area A). The BOM looks like you have to piece this short harness together? Is there a short harness assembly available. Also not shown are two twin line hose clamps that I also would like to replace.
Wire is continuous. No plug at either arrow. Between arrows is fuel hose (sleeve in parts list), and shrink tube at ends of hose, err, sleeve.