Hello, Does anyone know where the Implement pilot pressure solenoid is on a 924k? Thanks
Inside the front frame, near the control valve. Two wire connector, orange and yellow wires. Solenoid # 251-3268 Wire # G962 orange H807 yellow
Thank you, we changed the pilot pressure solenoid but still have the same problem. Is there another solenoid that controls the hydraulics. The same code is coming up.
And the fault code is? And the serial number is? We're not mind readers, most of the time
Yep, first mention of an active code, probably would have been good information to begin with. Like heymccall said, serial number gets you access to unlimited information.
fault code is 358-06[02] Serial # PWR01958
358-06 is confirmed for the implement pilot solenoid (current above normal) but if you have changed the solenoid and the Code is still there ( did you simply change the coil or the complete valve? ) then it is possible that you may have a wiring fault. Try the attached procedure from Page 8 and see where it gets you. If you would like a complete electrical schematic for the machine please ask.