Heavy Equipment Forums Heavy Equipment Community

Clam shell

DSPservicesLLC ยท 2016-09-18 22:04

Hey guys looking to build a clam shell bucket for a PC600. Will be a 4 yard bucket. I need some help with finding a good swivel and rotational hyd valve block Any help would be appreciated thanks guys

Replies5
  1. #1theironoracle2016-09-22 13:20

    HKX.com I worked with them on one project and they were very patient and helpful and not over priced.....TIO

  2. #2DK882016-09-22 14:16

    recently i put a hkx kit on a unit and it came with an aux wessell?( iirc correctly) valve, nice small unit and super easy to adjust and set.. flows and pressures are easily adjusted on each circuit.. just gotta make sure after you install the kit to cycle it a few times then go over all the hose connections again and then finally tighten down the mounting bolts and clamps otherwise you will chase leaks for a week or 2.. also sometimes they hose sizes can be a little large, again depending on application.

  3. #3lantraxco2016-09-22 16:13

    This clamshell going to be a dangle, or rigid mount?

  4. #4Firemanmike692016-10-14 22:14

    Try rotobec as well or Young.

  5. #5DSPservicesLLC2016-10-17 08:50

    Thanks for the feedback guys they put project on idle for now. Sorry have not been on here in quite some time