Heavy Equipment Forums Heavy Equipment Community

D6C part number

D6Cat ยท 2020-11-21 20:20

I'm am need a part number for a part on the hydraulic tank. It is the piece that the pressure line on the hydraulic attacks to.

Replies12
  1. #1D6c10K2020-11-21 21:24

    There are several variations in tanks and lines. You'll need the serial no. To find what you're looking for.

  2. #2Nige2020-11-22 06:19

    To identify parts on the tank would require the Serial Number of the Hydraulic Control. Fortunately that S/No is right there on the tank itself - or should be if it has not gone missing.

  3. #3D6Cat2020-11-22 11:01

    The s/n number on the hydraulic tank is 39615476 as best I can tell.

  4. #4Nige2020-11-22 11:07

    Close. The options for the first three digits are 39F, 39G, or 39X. Could the "6" be a "G" do you think..? Can you post your photo again.? It doesn't show up now.

  5. #5D6Cat2020-11-22 19:11

    It is very possible 39g instead of 396.

  6. #6D6Cat2020-11-22 19:19

    https://photos.app.goo.gl/ztoPvxtXHR4GGyhT8

  7. #7D6Cat2020-11-22 19:29

    https://photos.app.goo.gl/i7z7QXQRcbLb2qby9

  8. #8Old Magnet2020-11-22 20:15

    Looks like you need elbow 3P1288

  9. #9D6Cat2020-11-22 21:20

    Thanks guys I'll look this part number up.

  10. #10kshansen2020-11-23 08:42

    Well here's a picture out of the parts book on SIS that shows that 3P1288 as item # 7 in the drawing: And this is what the NPR says: Discontinued but does give a phone number to try: Then again if there is a place that is parting out Cat equipment you might get lucky and find a good used one, what's wrong with your's?

  11. #11Old Magnet2020-11-23 11:51

    Do a parts check on www.machinerytrader.com , they show several available.

  12. #12Welder Dave2020-11-23 20:53

    Looks like there's a big chunk broke out of it below the 90.