Please help! My employee opened the cab on my machine and didn't disconnect the throttle rod quick disconnect. Consequently when the cab opened it ripped the top half of my injector pump clean off. I have had the injector pump rebuilt, but now my throttle Rod is bent which I'm going to replace. However I do not know for certain if the linkage arm that is connected to the Deceleration pedal linkage is bent as well. The linkage arm that has the ball bolted to it appears to have a 30 degree Bend towards the inside of the machine. I am not sure if that is a factory Bend or if that linkage arm that the quick disconnect is connected to was bent during the cab opening procedure?. Can anyone shed some light on this and possibly send me a picture of their throttle Rod while it's connected to the injector pump and the quick disconnect linkage arm. From what I understand new Hollins and case dozers are identical so anyone with a case 750k or 850k would be able to shed some light and it would be very much appreciated. I posted pix of my current linkage.
No replies yet.