New to the forum. We recently bought a d6h. We are putting in a new equalizer bar, the center pin and the right track frame have a bit of play. Maybe a little under a 1/8th inch in center pin, and a hair over that on the right track frame. We thought the best thing to do would be to have them line bored. Are there any other options? The other question is we are located south of Kansas City. Was wondering if anyone would know a company that would do it around that area. Thank you.
I have line bored a good number of D6 centre pins. They are easy enough to do. From memory the bore on the track frame is a bit more of a challenge but quite doable. The centre pin is an interference fit. The bores should be welded,preferably with an auto welder and cut to spec.