Would like to get a new carburetor for this OLD forklift--FGH29 ... It has an Aisin small progressive 2 barrel carburetor that I replaced many years ago.21100-76008-71 tag#23035. I have not been able to find a supplied for this carb, Seems like no one has any inventory. any ideas? Thanks!
propane or gas? picture? maybe adapt a small marine carb?
Gasoline, hard to come up with a picture, but thanks for asking , I will try
well, 2 bolt flange? 4 bolt? what's wrong with the carb? pull and clean?
How old? 1950s?
4 bolt flange (small) can't even find a kit, while using the carb numbers. I am thinking 60's to 70's
Is the carb full of junk or worn out? Matching the last carb numbers is tough https://www.ebay.com/itm/315788050798 looks close. but that's 80s
It looks just like that... I may have to try to get that and see. Thanks You!
So what happened to your carb?
Has a hard time idling, must have dirty jets. can't find a kit, and don't want to chance tearing gaskets when taking the carb apart. May try to blow out the orifices in the top of the carb and the idle jet.
Hmm if it has a fuel filter it should not have too much of an issue with dirt. You might have a manifold gasket leak or another misfire issue. If you can start the engine, warm it up enough to run and run a little garden hose over the intake system and listen for a change or you might hear it sucking. could also be a low voltage or ignition misfire.
found a close looking carburetor with a manual choke- maxspeeding brand- had to remove a spacer from under the original- it was a velocity governor with a throttle butterfly. Interesting note- the governer block/spacer had only one port for the engine intake, but the actual intake had 2 throttle ports, the replacement carb used the port hole that was blocked by the governor adapter! Got it running and it sounds fine, will have to make some fuel line & throttle linkage changes.
toyota r18 -20 engine ,