Hello! We have a genie s-125 and when you raise the boom it stops at 10 degrees and display fault code p22 safety switch fault and p22r safety switch fault. I replaced the platform tilt sensor but it made no difference. Genie told me it might be the platform ecu but im not sure how to check that. So , does any one here have a clue how to proceed from here? Best regards //Johan
If it's the s125 I'm thinking of check the axle sensors. There's a sensor on each axle that won't let you boom up if the axles aren't fully extended. If this doesn't have extendable axles disregard this response.