I'm gettin a 10542-12 and 10044-01 , you can delete the codes in the monitor and the machine runs good still uses def , the def gauge only goes down to about 80 percent so not sure if it's a header issue , going to swap out nox sensors on a good machine and try that , itll run fine for a few days or a few hours before it throws codes , any ideas
Any izusu guys on here
10542.12 is for NOX efficiency. There are many reasons that could cause this from a bad DEF injector, EGR issues, fuel injector issues, DCU (Dosing Control Unit) issues, NOX sensor issues and so on. Clearing it in the monitor will not clear it from the Dosing Control Unit. The Isuzu in the Hitachi has special test procedures for the DEF system that requires MPDr.
We got all John Deere track hoes 350s and I know my way around them , we are trying out the hitachis for being twin machines they do have there differences
10542-12 and 10044-1 are SPN-FMI codes. They are equivalent to DTC P2000 and P20C9 codes of Isuzu Engine. Please see the attached files for more details. Hope to be helpful. Good luck.
Here are the PDF files for more details.
Thank you much appreciated