hey guys Does anyone know what the lift weight capacity is for an IT24F? I tried researching on google but could not find any info
Is this what you're looking for.?
yes that is what I am looking for It can carry the weight to full height?
As far as I am aware, yes.
The spec states with level arms and forks. Center of gravity changes as the load goes higher indicating static tipping load will decrease some. In general we used to figure load capacity at somewhere around half the total weight of the machine or a little less. Articulate the machine to the stops and it decrease again.
Based on the numbers above max lifting capacity in the LH column is 7155 lbs with the machine articulated to the max 40-deg angle. At the same articulation angle the static tipping load is 9541 lbs, so a factor of 33.3%. Apparently wheel loaders/IT are load-rated according to SAE standard J1197 when equipped with forks. According to that the safe load limit is 50% of the full-turn static tipping load. Attached a spec sheet for an IT38H which seems to bear that out. Based on that the IT24F would be rated 4770 pounds under the SAE J1197 standard.