i have a JD 750 C Dozer with a semi u 10' straight blade. When I begin to make a push and lower the blade in I am getting a lot of side to side slack, everything that I can see is tight . It doesn't seem to matter if I pitch the blade back to carry more dirt or pitch it forward to carry less. Anyone have advice on what this is or how to correct it ?
I dont no about the 750c but if it has The braces from the push arm to the back of the blade that is what controls side slop in the blade
Depends on blade setup, if blade arms are outside dozer frame may need to shim up sockets at rear. If it’s a c-frame could be the ball not seat in middle or pins/housing worn on rear pins