Hi, new to the forum. I have a John Deere 318d Only have power to the hydraulic solenoids for a few seconds after start up. Then it shows codes. 523217.06 and 523219.06. Did find a corroded connector at the pork lock solenoid, replaced connector and tested the solenoid and valve. They work good. Still no hydraulics. Any help would be greatly appreciated! Thank You!
я have service manual for it. my e-mail [email protected]
Check continuity at your solenoids. You may have one or more that have too low of resistance. It will pull the controller too low causing it to shut down and stop putting out voltage.
This is a duplicate posting. See this thread: HeavyEquipmentForums