Hello, I replaced a step motor, rpm sensor and mechatro controller on a SK250-6 machine. After it I wanted to do an AB adjustement, but it was not running suscsessfully, the step 1 step 2 step 3 were OK but by step 4 monitor wote CONDITION ERROR, The engine was increasing the RPM, but did not finish it. After it the monitor in RUN mode wrote ROM DATA error. Could you help me? what should be the issue?
It's so funny!!! This is the troubleshooting for Kobelco SKxxx Mark V, not SK250-6 ???!!! So I think the Mechatronics controller you just replaced is wrong???!!!
Press buzzer stop switch when maximum RPM reaches while running A adjustment