I am trying to remove the starter on an LB90 backhoe. I have the 1st. 2 bolts but can’t get the back one. Any ideas. Just can’t reach it.
I found a video about doing that on a similar machine. Maybe it helps?
The starter in the video seemed to only have 2 bolts. Yours is a 3-bolt unit (per looking it up, pic below). Have you tried an extension with a swivel on the end? I usually put a couple wraps of electrical tape on the swivel joint to tighten it up so it will stay at the angle you bend it to...helpful in a hard to reach spot.