My Marklift CH44C will not start (doesn't turn over either, acts dead) from the platform. It starts fine at the ground control panel. I replaced the off/on/start switch (the old one tested good). The 20A circuit breaker tests good. I cleaned the ground terminal on the battery and the frame. The emergency stop is pulled out. The foot switch is working correctly. All the other functions on the platform control panel are working correctly. There are 4 relays located on a panel near the engine. One tested bad and was replace. Very seldom, but every so often I hear a quick click down by the motor, possibly the starter solinoid kicking on for a split second? Any suggestions on which wire(s) to check and where they are located?
No replies yet.