Have a Genie Z80, it was working fine now it will not drive. The drive enable light is flashing, pushed the button and tried driving it and wont do forward or backward. All the booms work steering works. One wheel is higher than other wheel. Any ideas?
i have Snorkel tb 66j that does same thing, without any flashing light, at first i thought it was tilt sensor it is within prameters. inside both circles. fluids are full, oils are slightly low on hydraulics, well above fill mark. checked wiring not inch by inch but thorough inspection. looked at bucket control board as well as lower controls nothing obvious on the card and voltages seem ok, even checked limit switches i could and hydraulic solenoids. out of ideas